|
(Budapest
setup)
(initial
assault)
(strategic
map)
|
1945:
Operation Konrad recreates the
German attempt to relieve the Russian siege of
Budapest, the Hungarian capital, in early 1945.
1945:
Operation Konrad is a turn
based wargame. It uses classic rules like hexes,
ZOC's, combat odds, supply, multi-steps units,
replacements, reinforcements, bridge destruction
/ repair, artillery bombardments, special support
units, exploitation phase, etc. It is played on a
map of 60x30 hexs, with an average of 100 units.
There is one full campaign scenario that lasts
for up to 14 turns. One player will control the
axis army (German and Hungarian units), the other
plays the allied forces (Soviet and Rumanian
units).
Domain
: Shareware. 10-use trial.
$10.00 to register.
Config : Win
9x/2K/ME/NT/XP. 16MB RAM. 800x600x16bits display.
Play By Email :
YES
Play By Net / Internet :
NO
Includes Computer Opponent :
NO
Download the
free trial version of the game
(size = 9 Mb - for
Windows 9x/Me/2000/NT4/XP)Several
servers at your disposal (in case of
temporary slow trafic) :
Once
downloaded, run "kwdok.exe"
and follow install instructions.
If
you later decide to purchase this game
you won't have to download another
version; you will receive codes that will
enable all features.
|
FAQs
& Tips
Where
is the "Next Phase" button ? Your
screen display configuration does not meet the
minimum requirements. This game has been designed
to run on a 800x600 pixels (with more than 256
colors) screen resolution. Also, the font size
must be set to small (100% of standard Windows
font size). This config can be achieved on any PC
with a 1Mb video card aboard. Check the display
options in your windows config panel.
How
to add muti-units stack to a combat ? When a hex contains more
than 1 unit, only the top one can be selected. To
select the bottom unit, you need to
"circle" through the stack; right
clicking (right button) on a stack will change
units position in the stack, moving the bottom
one to the top. So, select the top unit (left
click), circle through the stack (right click),
then select the new top unit; this way, both
units are selected.
How
to move a whole stack at once ? This is not possible.
|
2M GAMES
***
|
